lightning monitor
"
RS485 RS232 雷撃モニター 接地抵抗モニター 220V AC 12V DC
Product description ● Support for standard 35mm rail mounting and flat panel mounting, 1 inch OLED display, Standard MODBUS-RTU protocol. ● 1 group E/P/C test terminal for connecting grounding electrode, voltage test electrode and current test electrode respectively. ● Two-pole method, three-pole method, volt-ampere method test principle. ● Maximum/minimum/average grounding resistance can be measured. Resistance Test Range 0 ~ 200 Ω,resolution 0.01 Ω ● Can Choose 1 DC 12V
多チャンネル雷撃カウンター 9999 桁 0.5kA-100kA 電流 2 チャネル RS485 通信インターフェース
Description This system is designed for monitoring and intelligent management of surge protectors, including recorded lightning strike counts, strike duration, remote signaling data, status of pre-breakers, and operational status of lightning arresters.Features • Display lightning arrester discharge count and status of two switch signals online • Microprocessing and digital storage ensure accurate data recording, interference-free operation, and data retention during power
機械式避雷カウンター IP67 3kA-100kA 電源サージ記録なし
LSC-3000 Mechanical Lightning Strike Counter is mainly used for counting direct lightning strikes of external lightning protection systems (such as lightning rods, down conductors) or lightning strikes of T1/T2 type surge protectors in power distribution systems. It adopts a German brand mechanical dial, featuring reliable performance without the need for power supply. With IP67 protection level, the counter is dustproof and waterproof, suitable for outdoor installation in
広範囲雷電流カウンター、500A-100kA デュアル波形 LPS イベントレコーダー
Wide-range lightning current counter complying with IEC 62561-6, compatible with both 8/20μs induced surges and 10/350μs direct lightning waveforms. Minimum trigger current 500A captures faint switching impulses, while max withstand capacity reaches 100kA (8/20μs) and 50kA (10/350μs) for heavy lightning strikes, without counting deviation after repeated high-current impacts. Self-powered lithium battery enables years of unattended logging, equipped with time lookup, count
防雷ネットワーク SPD 110V 160V 5kA 10kA 2型 3型 SPD
Product description Designed for installation in LPZ 2-3 and subsequent lightning protection zones, this fine-wire lightning arrester delivers dedicated lightning protection for end-level equipment in both AC and DC power systems. It is typically installed in series at the front of the protected equipment to clamp transient overvoltages effectively. Product features ● Full-Mode Surge Protection: Dual-port design provides comprehensive protection against all surge modes,
電気機器の雷による損傷を防止する 3相 SPD
Product Description Induced lightning surges and grid switching transients often burn industrial mainboards, inverters and building low-voltage hardware. This 4-pole three-phase SPD acts as secondary protection in LPZ0B-LPZ1 cabinets, conducting and diverting surge currents within 25ns to clamp residual voltage to safe ranges and reduce overvoltage breakdown risks for downstream electronics. 40kA maximum discharge capacity withstands repeated heavy lightning impulses; anti
全屋敷防雷 T1 T2 SPD 三相 280V 12.5kA 30kA 50kA DINレールマウント
LPM H12.5M-280/3+NPE is a T1+T2 level power surge protector designed for three-phase power supply systems. It adopts a mixed-technology design (MOV for L-N, GDT for N-E) to provide comprehensive protection against direct and indirect lightning strikes. Benefits Minimize Downtime: Hot-swappable modules let you replace faulty units in minutes, no power shutdown required, even in high-vibration industrial environments. Operate Safely in Extreme Cold: The ultra-low temp release
ナイロン電波防護装置 SPDS LED SPD 220V 5kA 10kA IP67 屋外雷保護
LPF Series is a specialized surge protector designed for LED street lights, sensors, and other outdoor equipment, suitable for installation in LPZ 2-3 and subsequent lightning protection zones. It adopts a one-port full-mode protection design, providing comprehensive shielding against surges in line-neutral, line-earth, and neutral-earth paths. Featuring small size (42mmx30mmx23mm) and easy installation, the product is ideal for space-constrained outdoor applications. The
ネットワーク2イン1 全屋電圧保護 220V 5kA 100M ビデオモニタリング IPカメラ
LS-PN Series Power & Network 2-in-1 Lightning Arrester is designed for LPZ 2-3 and subsequent lightning protection zones, suitable for CAT-5 class lines and power supply lines of video monitoring systems and BASE-T computer network information systems. Applications ● Video monitoring system power and network lines ● BASE-T computer network information systems ● CAT-5 class line protection for industrial and commercial networks ● Security camera power and signal lines ● Small
